| – Click on each photo to see a larger version. – |
 | Vaulted ceiling with 1-1/2 inch polystyrene vent system and 9 inches of Icynene Foam Insulation R40, 98% thermal performance, and complete air seal. |
 | NCI installing 1-1/2 inch polystyrene vent system. (full cavity vent system, 2 to 5 inch vent space, rigid foam backer, additional R-value) |
 | Bonus room in attic truss with 8-1/2 inches of Icynene Foam Insulation R30, 97% thermal performance, and complete air seal. |
 | Vaulted “Hot Roof” (non-vented) with 10-1/2 inches of Icynene Foam Insulation R38, 98% thermal performance, and complete air seal. |
 | Exterior walls with 5-1/2 inch full fill Icynene Foam Insulation R20, 95% thermal performance, and complete air seal. |
 | Rim Joist with 6 inch R21 Icynene Foam Insulation. |
 | Pole Barn walls with 4 inch average Icynene Foam Insulation R14.4, 92% thermal performance, and complete air seal. |
 | Pole Barn Roof with 1-1/2 inch polystyrene vent system and 4 inches R22, 96% thermal performance, and a complete air seal. |
 | Pole barn with 4 inch average Icynene foam walls and 6 inch average Icynene foam roof system. |
 | Windwash area with cardboard vent chutes and 6 inches of Icynene Foam Insulation. |
 | Remodeled 2x6 vault with 5 inches of Closed cell foam insulation R30. |
 | Remodeled 2x4 walls with 3 inch R18 Closed Cell Foam. |
 | Garage floor system with 3 inches of Closed Cell Foam. |
 | Bonus room above garage with 3-inch Closed Cell walls and 4-inch Closed Cell roof. |
 | 2x6 walls with 5-1/2 inch Icynene Foam insulation. |
 | Flat ceiling with 4-inch foam air seal, prior to an R40 of blown fiberglass |
 | Flat ceiling prior to insulation.
(We install 3 to 4 inches of Icynene Foam, then an R40 blown-in fiberglass, R50) |
 | Flat ceiling with 3 to 4 inches of spray foam insulation and R40 of blown fiberglass for a total of an R50. |
 | Flat ceiling with cardboard vent chutes at the wind wash and 6 inches of spray foam insulation. |
